The ISL6119 is a USB dual port power controller, fully independent overcurrent (OC) fault protection IC. Operational over the +2.5V to +5.5V range, this device features internal current monitoring, accurate current limiting, integrated power switches and current limited delay to latch-off for system protection.
The ISL6119 current sense and limiting circuitry sets the current limit to a nominal 1A, making this device well suited for the USB port power management application. The ISL6119 provides OC fault notification, accurate current limiting and a consistent timed latch-off thus isolating and protecting the voltage bus in the presence of an OC event or short circuit. The 12ms time to latch-off is independent of the adjoining switch's electrical or thermal condition and the OC response time is inversely related to the OC magnitude.
Each ISL6119 incorporates in a single 8 lead SOIC package two 80mΩ N-channel MOSFET power switches for power control. Each switch is driven by a constant current source giving a controlled ramp up of the output voltage. This provides a soft start turn-on eliminating bus voltage drooping caused by inrush current while charging heavy load capacitances. Independent enabling inputs and fault reporting outputs for each channel are compatible with 3V and 5V logic to allow external control and monitoring.
The ISL6119 undervoltage lockout feature prevents turn-on of the outputs unless the correct ENABLE state and VIN >2.5V are present. During initial turn-on the ISL6119 prevents fault reporting by blanking the fault signal. Rising and falling outputs are current limited voltage ramps so that both the inrush current and voltage slew rate are limited, independent of load. This reduces supply droop due to surge and eliminates the need for external EMI filters.
During operation, once an OC condition is detected the appropriate output is current limited for 12ms to allow transient conditions to
|
|
|
• USB Port Power Management• Electronic Circuit Limiting and Breaker
|
• 80mΩ Integrated Power N-channel MOSFET Switches• Accurate Current Sensing and 1A Current Limiting• 12ms Fault Delay to Latch-Off, No Thermal Dependency• 2.5V to 5.5V Operating Range• Disabled Output Internally Pulled Low• Undervoltage Lockout• Controlled Turn-on Ramp Time• Channel Independent Fault Output Signals• Compatible with 3.3V and 5V Logic Families• Channel Independent Logic Level Enable High Inputs (ISL6119H) or Enable Low Inputs (ISL6119L)• Pb-Free Package Options• Available in Tape & Reel with '-T' Part Number Suffix
|
Supply Voltage (VIN to GND). . . . . . . . . . . . . . . . . . . . . . . . . . . 6.0V
EN, FAULT. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 6V
OUT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GND -0.3V to VIN 0.3V
Output Current . . . . . . . . . . . . . . . . . . . . . . .Short Circuit Protected
ESD Rating
Human Body Model (Per MIL-STD-883 Method 3015.7) . . . . . . 3KV
Post a Buying Lead
Required Field 
